Toshiba D-R4SC - Manual (Page 44)

44
D: Remote control settings (Continued)
Basic Setup
Operating the second and third TOSHIBA DVD video recorders with the remote control of this recorder
Switches the codes to operate the recorder.
If you use the second and third TOSHIBA DVD video recorders, set the different remote codes for each recorder to
avoid confusion in the response of the recorders.
Example: Setting this recorder’s remote control mode to DR 2, after another DVD recorder has been set to
DR 1.
(It is necessary to set the remote control mode on both the recorder and the remote control.)
Setting up the recorder
1
Press SETUP.
The setting menu appears.
2
Press / to select “Operational settings”,
then press SELECT/ENTER.
3
Press / to select “IR code”, then press
SELECT/ENTER.
4
Press / to select “DR 2” (example), then
press SELECT/ENTER.
The submenu disappears.
By pressing the SELECT/ENTER button, the selected
command mode is set in the recorder. Operation may not
be possible temporarily until you set the corresponding
mode in the remote control itself. Proceed to the next
setting.
SELECT/
ENTER
SELECT/
ENTER
SETUP
SELECT/
ENTER
OPEN/CLOSE
ANGLE
DISPLAY FL SELECT DIMMER
SUBTITLE AUDIO/SAP FREEZE
REMAIN REC MODE EXTEND
SETUP
VOL CH
TIMESLIP
INPUT SELECT MUTE
MENU
TV
DVD
EASY
NAVI
INSTANT
REPLAY
INSTANT
SKIP
TOP MENU
QUICK MENU
SKIP REV STOP SKIP FWD
FWD PLAY REV
REC
SEARCH
T
ADJUST CHP DIVIDE
CLEAR
ZOOM
PROGRESSIVE
1 2 3
4 5 6
+10
7 8 9
0
SELECT/
ENTER
SETUP
e.g.
Instant skip interval 30
10
35 sec.
sec.
sec.
3 sec.
Operational settings
IR code DR 1
Title thumbnail point
Title resume
Instant replay interval
Photo
Title playback
Still group interval
Priority contents
SETUP
e.g.
Instant skip interval 30
10
35 sec.
sec.
sec.
3 sec.
Operational settings
Title thumbnail point
Title resume
Instant replay interval
DR 1
DR 3
DR 2
Photo
Title playback
Still group interval
Priority contents
IR code DR 1
Start