Troy-Bilt 106 - Manual (Page 12)

12
performance and flooding usually indicates that the
air cleaner should be serviced. To service the air
cleaner, refer to the engine manual.
• The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended at the start of each mowing season;
check engine manual for correct plug type and gap
specifications.
• Clean engine regularly with a cloth or brush. Keep
the cooling system (blower housing area) cleaned
to permit proper air circulation which is essential to
engine performance and life. Make sure to remove
all grass, dirt and combustible debris from muffler
area.
SECTION 8: OFF-SEASON STORAGE
The following steps should be taken to prepare lawn
mower for storage.
• Clean and lubricate mower thoroughly as described
in the lubrication instructions.
NOTE: We do not recommend the use of pressure
washers or garden hose to clean your unit. They may
cause damage to electric components, spindles,
pulleys, bearings or the engine. The use of water will
result in shortened life and reduce serviceability.
• Refer to engine manual for correct engine storage
instructions.
• Coat mower’s cutting blade with chassis grease to
prevent rusting.
• Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust-proof the equipment. Using a light oil or
silicone, coat the lawn mower, especially cables and all
moving parts, before storing it for the off-season.
SECTION 9: TROUBLE SHOOTING GUIDE
Trouble Possible Cause(s) Corrective Action
Engine fails to start 1. Blade control handle disengaged.
2. Spark plug wire disconnected.
3. Fuel tank empty, or stale fuel.
4. Blocked fuel line.
5. Faulty spark plug.
6. Engine flooded.
1. Engage blade control handle.
2. Connect wire to spark plug.
3. Fill tank with clean, fresh gasoline.
4. Clean fuel line.
5. Clean, adjust gap or replace.
6. Wait a few minutes to restart. Do not prime.
Engine runs erratic 1. Spark plug wire loose.
2. Blocked fuel line or stale fuel.
3. Vent in gas cap plugged.
4. Water or dirt in fuel system.
5. Dirty air cleaner.
6. Carburetor out of adjustment.
1. Connect and tighten spark plug wire.
2. Clean fuel line; fill tank with fresh gasoline.
3. Clear vent.
4. Drain fuel tank. Refill with fresh fuel.
5. Clean air cleaner.
6. Adjust carburetor.
Engine overheats 1. Engine oil level low.
2. Air flow restricted.
3. Carburetor not adjusted properly.
1. Fill crankcase with proper oil.
2. Remove blower housing and clean.
3. Adjust carburetor.
Hesitates at high
speed 1. Spark plug gap too close. 1. Adjust gap to .030”.
Idles poorly 1. Spark plug fouled or gap too wide.
2. Carburetor improperly adjusted.
3. Dirty air cleaner.
1. Reset gap to.030” or replace spark plug.
2. Adjust carburetor.
3. Clean air cleaner.
Excessive vibration 1. Blade loose or unbalanced.
2. Bent cutting blade.
1. Tighten blade and adapter. Balance blade.
2. Replace blade.
Mower will not mulch
grass 1. Wet grass.
2. Excessively high grass.
3. Dull blade.
1. Wait until later to cut.
2. Mow once at high, then mow again lower.
3. Sharpen or replace blade.
Uneven cut 1. Wheels not positioned correctly.
2. Dull blade.
1. Place all four wheels in same height position.
2. Sharpen or replace blade.