Trango Broadband High Density Mesh System User Manual

Page 13

Advertising

HD Mesh Node

Trango Broadband Wireless — High Density MESH

page 13

Command Line Interface

The Web browser interface covers very basic features in a limited role. The command line interface

(CLI) provides much more functionality, and is usually the management tool of choice for experienced users.
The CLI can be accessed through Telnet or Console cable.

Telnet

Open a command prompt (DOS) session on your PC. Open a Telnet session by typing:

telnet [ip address of router]

All HD mesh units are pre-configured at the factory. The factory default username is admin and password is
trango. Once you connect to the router you will be greeted with the current RouterOS version information and
prompted for a login.

CLI Login Example

C:>telnet 192.168.100.100

MikroTik v2.9.32

Password:

MMM MMM KKK TTTTTTTTTTT KKK

MMMM MMMM KKK TTTTTTTTTTT KKK

MMM MMMM MMM III KKK KKK RRRRRR OOOOOO TTT III KKK KKK

MMM MM MMM III KKKKK RRR RRR OOO OOO TTT III KKKKK

MMM MMM III KKK KKK RRRRRR OOO OOO TTT III KKK KKK

MMM MMM III KKK KKK RRR RRR OOOOOO TTT III KKK KKK

Terminal ansi detected, using single line input mode
[admin@HDMESH] > quit

To terminate a CLI session (Telnet or Serial) type the command quit.

Note: Type ? for a listing of CLI commands and directories. More basic information on the CLI will

be covered throughout this text for advance CLI commands reference Mikrotik’s website for
documentation

www.mikrotik.com

Advertising