Topcom DIABLO 103 User Manual
Page 7
Topcom Diablo 100/Twin/Triple/Quattro
7
Topcom Diablo 100/Twin/Triple/Quattro
ENGLIS
H
6.4
Erasing one or all number from the Call list
Scroll through the Call list until the desired number is shown on the display.
Î
Press the Mute button
short to erase the current entry or press and hold the Mute button
for 3 sec. to erase the compleet
call list.
6.5
Store a number from the call log into the memory
Scroll through the Call list until the desired number is shown on the display.
Î
Press and program
button
for 3 sec.
Î
The memory will be shown and you can scroll through it with the scroll keys
to see which entry is still empty (0-9)
Î
Enter the memory location (0-9) where you want to store
the number.
Î
Edit the number if needed and press the program button
again to confirm and to go
back to standby.
7
Register/de-register a handset
7.1
Register to a Topcom Diablo base
You can subscribe 5 handsets to one base unit. By default, each handset is subscribed on the base unit
upon delivery.
You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
•
You want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Diablo handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blink rapidly. The Line/Charge indicator
will blink rapidly for one minute.
During this minute, the base unit is in register mode and you must do the following to subscribe the
handset:
Press and hold the Program
key for 6 sec until there is a ‘-’ scrolling on the screen from left to right.
The handset is now searching for the base. When a base is found the handset will ask to enter the pin-
code ‘P1-_’. Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for
the base.
Î
When the handset is registered, it will show the handset number followed by the time.
8
Call transfer and Intercom between two handsets
8.1
Call transfer and conference call during an external call
During an external call, press and hold the INT key until INT appears . Press the number (1-5) of the
other handset.
Î
The other handset will start to ring:
–
When the other handset takes the line you can talk internally.
If you hang up, the external line will be connected with the other handset.
If you press the ‘#’-key you can talk with the 2nd handset and external line at the same time
(conference call)
–
Or press and hold the INT key again to return to the external call.
Press the On-hook button
to end the call.
8.2
Internal call (intercom)
In standby press and hold the INT key until INT appears . Enter the number (1-5) of the other handset.
Î
The other handset will start to ring.
Î
If the other handset answers the call by pressing the Off-
hook button
you can talk internally.
Î
Press the On-hook button
to end the call.
These functions only work when more then one handset (like a Twin/Triple/Quattro
version) is registered to the base!