Tyan Computer S1854 - Manual (Page 64)

http://www.tyan.com
64
Chapter 4
System Resources
Troubleshooting System Problems
Currently the only beep code indicated that a video error has occured
and the BIOS cannot initialize the video screen to display any additional
information. This beep code consists of a single long beep followed by
two short beeps. Any other beeps are probably a RAM problem
Displayed Error Messages
If an error occurs after the system display has been initialized, the error
message will be displayed as follows:
ERROR Message Line 1
ERROR Message Line 2
Press <F1> to continue
and the system will halt. The system will not halt if the Wait for <F1> If Any
Error option in Advanced Setup is Disabled.
RUN SETUP UTILITY
may also appear. Press <F1> to run AwardBIOS Setup if this message appears.
Please see the following page for a chart for possible error messages and
explainations.