Topcom Butler 2800 - Manual (Page 11)

Topcom Butler 2800 11
ENGLISH
Topcom Butler 2800
8. CALL TRANSFER AND INTERCOM BETWEEN TWO
HANDSETS
!!! These functions only work when more then one handset (like a duo/twin version) is registered to the
base!!!
8.1 CALL TRANSFER AND CONFERENCE CALL DURING AN EXTERNAL CALL
• During an external call, press the INT key followed by the number (1 - 5) of the other handset.
• The other handset will start to ring:
-
When the other handset takes the line you can talk internally.
If you hang up, the external line will be connected with the other handset.
If you press and hold the INT key for 3 seconds you can talk with the 2nd handset and external line at the same
time (conference call)
- Or press the INT key again to return to the external call.
• Press the Line button to end the call.
8.2. INTERNAL CALL (INTERCOM)
• In standby press the INT key followed by the number (1-5) of the other handset.
• The other handset will start to ring. You can stop the ringing by pressing the Line button .
• If the other handset answers the call by pressing the Line button you can talk internally.
• Press the Line button to end the call.
9. TOPCOM WARRANTY
• This equipment comes with a 24-month warranty. The warranty will be honoured on presentation of the original bill
or receipt, provided the date of purchase and the unit type are indicated.
• During the time of the warranty Topcom will repair free of charge any defects caused by material or manufacturing
faults. Topcom will at its own discretion fulfil its warranty obligations by either repairing or exchanging the faulty
equipment.
• Any warranty claims will be invalidated as a result of intervention by the buyer or unqualified third parties.
• Damage caused by inexpert treatment or operation, and damage resulting from the use of non-original parts or
accessories not recommended by Topcom is not covered by the warranty.
• The warranty does not cover damage caused by outside factors, such as lightning, water and fire, nor does it apply
if the unit numbers on the equipment have been changed, removed or rendered illegible.
Note: Please do not forget to enclose your receipt if you return the equipment.
10. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
No Display Batteries not charged Check the position of the batteries
Recharge the batteries
No dialling tone Telephone cable not
properly connected Check the connection
of the telephone cable
Volume of conversation partner too low Adjust the volume during the conversation
by pressing the volume key
Handset ringer volume too low Adjust the ringer volume
H L _ B 2 8 0 0 . b o o k Page 11 Friday, August 29, 2003 1:16 PM