Teac A-H300mkIII - Manual (Page 7)

7
ENGLISH
AUDIO IN/OUT jacks
Analog 2-channel audio signal is input or output from these
jacks. Connect the component with commercially-available
RCA cables.
Make sure to connect :
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
SIGNAL GND
Connect the ground lead of the turntable to this terminal.
< This is not a safety earth.
AC OUTLET (unswitched)
Even when the unit is off, this outlet is active as long as the
power cord is connected to an AC outlet.
Caution:
Make sure that the total power consumption of all
equipment connected to the outlet(s) does not exceed 100
watts (or 500mA).
AC Power Cord
After all other connections have been completed, connect
the plug to the AC wall socket.
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord.
E
D
C
B Speaker Terminals
Caution:
To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting
the speakers.
Check the impedance of your speakers. Connect speaker
with an impedance of 6 to 16 ohms.
The black speaker terminals are _ (negative).
Generally, the + side of the speaker cable is marked to
make it distinguishable from the _ side of the cable.
Connect this marked side to the + terminal and the
unmarked side to the black _ terminal.
Prepare the speaker cables for connection by stripping off
approximately 10 mm or less of the outer insulation.
(Removing too much insulation may lead to a short circuit if
the bared wired should come in contact with each other.)
Twist the strands of the stripped wires tightly together:
A
Caution:
The metal portions of the two separate wires should not
touch or an electrical short can occur. Shorted wires can
create a fire hazard or induce a failure in your equipment.
How to connect:
1. Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the
base.
2. Insert the wire into the terminal fully and turn the terminal
cap clockwise to securely connect it:
Make sure none of the wire insulation is under the terminal,
only the bare, stripped wire.
3. Make sure it is fastened firmly by pulling the cable lightly.