Topcom 2511C - Manual (Page 9)

11. If the handset does not locate the base, it will return to the standby mode
after a few seconds.
Try again by changing the base number and check that you are not in a
environment where there is interference. Move closer to the base.
4.2 SETTING UP A BUTLER HANDSET ON ANOTHER BASE
If you want to use a Butler 2511C DELUXE handset with a base of another model.
The base must be GAP compatible.
1. To put the base in registration mode, refer to the base user manual.
2. Carry out operations 3 to 10 from the paragraph 4.1.
5. TROUBLE SHOOTING
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the
batteries
Recharge the batteries
Handset turned OFF Turn ON the handset
No tone Telephone cord badly Check the telephone cord
connected connection
The line is occupied by Wait until the other handset
another handset hangs up
The icon Handset out of range Bring the handset closer to the
flashes base
The base has no power Check the mains connection to
supply the base
The handset is not Register the handset on the
registered on the base base
Telephone does not Manipulation error Remove the batteries and
react to pressing but them back in place
the keys
ENGLISH
Topcom Butler 2511C DELUXE 9
HANDL. B2511_C.qxd 31-10-2003 10:45 Page 9