Tyan Computer TOLEDO S5520 - Manual (Page 62)

62
3.6 Power
Use this screen to select options for the Power Settings Configuration.
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Exit
Item Specific Help
ACPI Sleep Mode
Resume on Time
Resume Time
Chassis Intrusion detect
Power On By PCI
After Power Failure
[S1/S3]
[Off]
[No]
[Disabled]
[Stay Off]
Select one of the ACPI
power states: S1, S2, or
S3. If selected, the
corresponding power
state will support.
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
Esc Exit ← → Select Menu Enter Select X Sub-Menu F10 Previous Values
ACPI Sleep Mode
Select one of the ACPI power states: S1, S2, or S3. If selected, the corresponding
power state will support.
Options: S1/S3 / S1 / S3
Resume On Time
When enabled, this allows the system to be worked up at a specified time. This time
is specified by the Resume Time parameter.
Options: Off / On
Resume Time
This option allows the user to specify the time when the system is to wake up.
Chassis Intrusion Detect
This feature is used to enable/disable the function: when chassis open event is
detected, BIOS will record the event.
Options: No / Yes
Power On By PCI
This option allows you to power on the system by PCI or PCI-X card. When enabled,
an input signal from PME on the PCI card awakens the system from a S5 state.
Options: Enabled / Disabled
After Power Failure
Sets the mode of operation if an AC/Power Loss occurs. The two modes are:
[Enabled]: restores the previous power state before loss occurred.
[Disabled]: keeps the power off until the power button is pressed.
Options: Power On / Stay Off / Last State