Trango Broadband M5580M-FSU - Manual (Page 32)

Appendix B Specifications
Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2 page 28
Appendix B Command Set Summary
Command Description Remarks
Apsearch Search for near by APs.
arq [on|off] enable or disable ARQ default on
Bye Terminate or exit telnet/serial session
Exit Terminate or exit telnet /serial session
freq [<ch#> <antenna>] set or display channel settings default 1 h
freq scantable Displays current scan table
freq channeltable Displays current channel table
freq writescan <ch> <h/v> … Creates channel scan table
freq writechannel <ch#> <freq>… modify channel table, up to 30 channels Opmode off only
help [<command>] display commands and proper usage
ipconfig [<ip> <subnet> <gateway>] change ip configuration
<ip> = ip address
<subnet> = subnet mask
<gateway> = gateway ip address
default:
IP 192.168.100.100
SN 255.255.255.0
GW 192.168.100.100
log [<# of entries, 1..179>
log <sum> <# of entries, 1..179>
Logout Exit telnet session
opmode [off|su [y]] set or display opmode default off
password <ro|rw|upgrade> Change password
<ro> = for read-only
<rw> = for read-write
<upgrade> = for upgrading firmware default trango
ping <ip address> Ping ip address
polar <h/v> Sets antenna polarization Default: h
power [<dBm>] set or display tx power <dBm> Default 21
pppoeonly <on/off> Set radio to allow pppoe traffic only Default off
Reboot reboot unit
remarks [<str>] remarks, up to 80 characters
reset [all|0..2] reset all parameters to factory defaults
reset 0 XXXX parameters only
reset 1 XXXX parameters only
Rssi display RSSI for AP / SU and association status Opmode on only
set apid <id> Sets AP ids Default: 1
set baseid <id> Sets unit base id (Numeric Characters only 0 – 9) up to
999
Default: 1
set suid <id> sets SUs id Default: 1
set httpport [<1…65534>]
set telnetport [<1…65534>]
ssrssi [ch, h/v>] Search for best signal on a channel while in opmode off
survey <time, sec> <h/v> Survey for a clean non-interfered channel
sw [<sw #> <on/off>] Sets switches on or off
Sysinfo Displays system current information
syslog [<0/1> | clear]
tftpd [on|off] enable or disable tftpd default = off
enable for firmware
upgrade
tm
ver Displays current firmware version, MVC and hardware
version