TANDBERG Video Conferencing System 7000 - Manual (Page 19)

TANDBERG Videoconferencing System
19
Installation
System configuration
• Switch the system on by connecting the power cable to an electrical distribution socket.
• After the system has performed a self-test routine, product logo and a ‘Welcome’ menu will be displayed on the
monitor.
connect
menu
• Enabled but unused ISDN lines (lines not active) should be disabled. Select the Quick Key ‘System Info’ (on
the remote control) to view line status.
P
RESS
M
ENU ON THE REMOTE CONTROL
. S
ELECT THE MENU
‘T
ERMINAL
S
ETTINGS
’, ‘N
ETWORK
’, ‘ISDN-BRI
SETTINGS
’. S
ELECT THE
RELEVANT ‘L INE S ETUP ’ MENU AND SET ‘E NABLED : O FF ’.
• Enter System Name to identify the system during an MCU conference. Select ‘Utilities’, ‘System Name’ and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in ‘Terminal Settings’, ‘Language’.
• Please make sure that ‘Dual Monitor’ is set to ‘On’ in the ‘Utilities’ menu.
• To activate MultiSite and/or Presenter, enter an option key (see paperwork accompanying your system), see
‘Terminal Settings’, ‘Software Options’.
• Press C ONNECT on the remote control. A dial tone should be heard if the network is active.
• Press the V
OLUME
keys on the remote control to adjust the volume to a level of your choice.
T HESE SETTINGS ARE ESSENTIAL
FOR OPTIMAL SYSTEM SET - UP .
NOTE