Friction wheel removal – Troy-Bilt STORM TRACKER 2690XP User Manual

Page 21

Advertising
background image

Slip the drive belt off the pulley and between friction

7.

wheel and drive pulley. See Fig. 7-7.

Remove and replace belt in the reverse order.

8.

NOTE: Engaging the drive control will ease re-assembly of
the belt.
Reinstall the stop bolt.

9.

Friction Wheel Removal

The rubber on the friction wheel is subject to wear and should be
checked after 25 hours of operation, and periodically thereafter.
Replace the friction wheel rubber if any signs of wear or cracking
are found.

Allow the engine to run until it is out of fuel. Do not

1.

attempt to pour fuel from the engine.
Tip the snow thrower up and forward, so that it rests on the

2.

housing.
Remove the self-tapping screws from the frame cover

3.

underneath the snow thrower.
Using a

4.

3⁄4” wrench to hold the gear shaft, remove the hex

bolt and bell washer on the left end of the gear shaft. See
Fig. 7-8 and 7-9.

Move the gear shaft to the right and slide the friction wheel

5.

assembly from the shaft. See Fig. 7-9.

Drive Belt

Drive Pulley

Sprocket

Figure 7-7

NOTE: Tracks removed for clarity

Figure 7-8

Friction Wheel

Assembly

Gear Shaft

Figure 7-9

21

S

ection

7 — S

ervice

Advertising