Toshiba IK-65WDA - Manual (Page 19)

19
(7) WHITE BAL (WHITE BALANCE)
S H U T T E R D / N : M I D
WD R O N
A L C L E V : 0 0
B L C A U T O
G A I N S T D
S H A R P N E S S M I D
WH I T E - B A L A U T O : 0 0
N E X T
E X I T C A N C E L D E F A U L T
INDOOR1 : Optimum setting for the white balance when the color temperature is 3000K
indoors with an incandescent lamp.
INDOOR2 : Optimum setting for the white balance when the color temperature is 4000K
indoors with a fluorescent lamp.
OUTDOOR : Optimum setting for the white balance when the color temperature is 5200K
in an outside environment.
NOTES
• If the optimum white balance cannot be obtained, then try to set AWB-RNG
to WIDE. (Refer to 8.3 (11).)
(8) ID. = Camera ID.
Refer to 8.2 (6).
(9) ID. POS = Camera ID. Position
Refer to 8.2 (7).
Move the cursor to the position shown in fig.
Use the
SELECT switches to select
AUTO, MANUAL in the WHITE BAL settings.
AUTO : The white balance is automatically
adjusted corresponding to the color
temperature variations on the ob-
ject. The camera is applicable to a
color temperature range of 2500-
10K. Press the SELECT switch to
enter AUTO set mode. Use the
SELECT switches to adjust the shift
value of the convergence point.
When data becomes big in the positive side, a convergence point is altered in
the red side. When data becomes big in the negative side, a convergence point is
altered in the blue side.
MANUAL : Press the SELECT switch to enter the MANUAL SETTINGS. Use the
SELECT switches to adjust R Gain (Red) and B Gain (Blue) until the desired
white balance is reached. Press SELECT to exit the manual settings.