Univex DB285USB - Manual (Page 13)

Basic Operations
English
13
DB285USB
Sound Adjustment
You can adjust a sound effect or tone quality to
your preference.
● Setting the Z-Enhancer Plus
This unit is provided with 4 types of sound tone
effects stored in memory.
Select the one you prefer.
∗
The factory default setting is “OFF”.
2-1. Select “Z-EHCR+”.
3-1. Each time you turn the [ROTARY] knob,
the tone effect changes in the following
order:
“OFF” ↔ “B-BOOST” ↔ “IMPACT” ↔
“EXCITE” ↔ “CUSTOM ”
OFF : no sound effect
B-BOOST : bass emphasized
IMPACT : bass and treble emphasized
EXCITE : bass and treble emphasized
mid emphasized
CUSTOM : user custom
When “B-BOOST/IMPACT/EXCITE” is set:
3-2. Press the [ ] button.
3-3. Turn the [ROTARY] knob to adjust the
setting in the range of – 3 to +3.
∗
The factory default setting is “0”.
3-4. Press the [ ] button to return to the
previous mode.
When “CUSTOM ” is set:
3-2. Press and hold the [ ] button for 1
second or longer. Bass/treble
characteristics become flat and “FLAT” is
show in the display.
3-3. Turn the [ROTARY] knob to change to the
“OFF” mode.
● Adjusting the bass
This adjustment can be performed only when
the Z-Enhancer Plus is set to “CUSTOM ”.
2-1. Select “BASS”.
3-1. Press the [ ] button.
3-2. Press the [x] or [v] button to select as
following order.
“B<G 0>” ↔ “B<F 60>” ↔ “Q 1”
3-3. Turn the [ROTARY] knob to adjust the
gain, the F (center frequency) and the Q.
B<G 0> :The factory default setting is “0”.
(Adjustment range: + 7 to – 7)
B<F 60> :The factory default setting is
“60”.
(Adjustment range: 60/80/100/
200)
Q 1 :The factory default setting is “1”.
(Adjustment range: 1/1.25/1.5/2)
3-4. Press the [ ] button to return to the
previous mode.
To change sound setting
1. Press the [SOUND] button to switch to the
sound adjustment selection display.
∗
The factory default sound setting is “Z-
EHCR+”.
2. Then press the [x] or [v] button to
select the sound adjustment mode.
Each time you press the [x] or [v]
button, the sound adjustment mode
changes as following order:
“Z-EHCR+” ↔ “BASS” ↔ “TREBLE” ↔
“BALANCE” ↔ “FADER” ↔ “NF VOL”
∗
In the case of display blinking “ENT”, you
can press the
[ ] button to adjust the
setting value.
∗
The sound adjustment mode will be
displayed for 2 seconds before showing the
sound setting.
3. Turn the [ROTARY] knob to adjust the
selected audio mode.
4. After completing settings, press the
[SOUND] button to return to the previous
mode.