Uniden DCT5285 - Manual (Page 70)

Call Transfer Feature
From handset to handset or to the base
1) During a call, press intercom/hold on the handset.
2) Select a handset or the base to transfer the call to
within 10 seconds (refer to step 2 under “From handset
to handset or to the base” in the intercom section).
The call will automatically be placed on hold, and an
intercom tone sounds. To cancel the transfer, press the
CANCEL soft key, talk/flash, speaker or the BACK soft key on the initiating handset.
3) On the receiving handset, to answer the page, press talk/flash, intercom/hold, or the
ANSWER soft key (or int’com/hold or (talk) on the base). Or press any number key,
/tone/ t , or # /s (when Any Key Answer is On), or pick up the handset from the cradle
(when AutoTalk is On). The intercom mode is activated, but the caller is still on hold.
4) To speak to the caller, press talk/flash or speaker (or (talk) on the base) on the
receiving handset.
From the base to a handset
1) During a call, press int’com/hold on the base. The call will automatically be placed
on hold.
2) Select the handset you want to talk with by pressing the number key (1-4). To page all
the handsets press /tone/ t . An intercom tone sounds. To cancel the transfer, press
int’com/hold or (talk) on the base.
3) On the receiving handset, to answer the page, press talk/flash, intercom/hold, or the
ANSWER soft key. Or press any number key, /tone/ t , or # /s (when Any Key Answer
is On), or pick up the handset from the cradle (when AutoTalk is On). The intercom
mode is activated, but the caller is still on hold.
4) To speak to the caller, press talk/flash or speaker on the receiving handset.
E X PA N D I N G Y O U R P H O N E [ 68 ]
H o l d , t o t r a n s f e r
H a n d s e t # 2
H a n d s e t # 3
BACK BACK OK
Replacing the Base
When you replace the base with a different base of the DCT series model (DCT5260,
DCT5280, or DCT5285 series), you need to clear the handset and base ID. To do this,
perform the “System Reset” menu options (“De-register the Handset” and “Replacing the
Base Setting” (see page 30). Then register all the handsets you have (see page 65).
DCT5285_UP304BH UP01304BA_1 5/23/03 3:10 PM Page 68