Uniden DSS8955+3 - Manual (Page 55)

53 54
Troubleshooting
When you have this
problem...
Try...
I can’t join the conversation.
Checking to see that there are not two handsets already using the conference •
feature (see page 37).
Checking to see that another handset is not in privacy mode (see page 39). •
Making sure that you have registered all handsets (see page 12). •
Changing the handset to base code (see page 57). •
The answering system does
not work.
Checking the AC adapter connection (see page 7). •
Checking to see if the answering system is turned on (see page 46). •
The answering system does
not record any messages.
The memory may be full. Delete some or all of the saved messages (see page •
47).
Checking to see that the message record time is not set to announce only (see •
page 44).
The answering system
doesn’t say what time
messages were recorded.
Checking to see if you have set the time (see page 44). •
Messages are incomplete.
The incoming messages may be too long. Ask callers to leave a brief message. •
The memory may be full. Delete some or all of the saved messages (see page 47). •
I can’t hear base or handset
speaker during call screening
or message playback.
Adjusting the speaker volume on the base or handset (see page 36). •
Checking to see if the call screen feature is set to on (see page 45). •
I can’t access answering
system from a remote
phone.
Checking to see if you are using the correct PIN number (see page 48). •
Checking to see if the touch-tone phone you’re using can transmit the tone for at •
least two seconds. If it cannot, try using a different touch-tone phone.
DSS8955 OM.indb 54 28/7/08 5:21:05 PM