UTStarcom The CDM8915 - Manual (Page 8)

BATTERY USAGE BEFORE USING
■ BATTERY INSTALLATION
As shown in the picture below, put the metal locators of the
battery into the holes located in the bottom of the unit.
Place the battery on the back of the handset and
slide into place.
Push the battery down until it locks into place.
13
If the battery is not correctly placed in the compartment,
the handset will not turn on and/or the battery may detach
during use.
BEFORE USING DISPLAY INDICATORS
12
Etiquette
Phone will vibrate when call is received.
Schedule
When the Schedule is set, the idle screen appears. The idle
screen disappears if the schedule expires or is disabled.
Alarm
When the Alarm is set, the idle screen appears. The idle
screen disappears if the alarm is in operation or disabled.
Dormant
Indicates your phone is in a dormant state during a data
call. Your phone lapses into Dormant mode when you have
not had any activity on a page for some time - your
connection is still active and you can make and receive calls.
Data Only
Phone is ready to receive a data call.
GPS Icon
Indicates the Location Service of your phone is
disabled/enabled.
1X
Phone is in the 1x service area.
Scratch Pad
Displays when scratch pad is in use during a call.
UP Browser
UP Browser is in use.
Web Message Icon
Phone has Web Alert message. (Web
Message + TEXT Message + Voice Message)
Ring Mode
Appears when a ringer is set for the
ringer mode.
■ BATTERY REMOVAL
Pull up the release latch, lift up the battery.
Remove the battery from the handset.
ᕡ
ᕡ
ᕢ
ᕢ