Ultratec INTELE-MODEM - Manual (Page 15)

1–Communication code (The default is
Automatic code detect)
This command has three possible
settings: Automatic code detect, Baudot
code, and ASCII code.
Automatic code detect–The modem
automatically matches the caller’s
code. If he or she is using ASCII, the
Intele–Modem uses ASCII. If the call is
in Baudot code, the modem uses
Baudot.
Note that while Automatic code detect
can switch codes automatically, it
cannot switch speeds. If you get a call
in ASCII code at 110 baud, press the
Escape Key to enter command mode,
type 3 to switch to 110 baud, and press
Enter to return to on-line mode.
Similarly, if you get a call in Baudot
code at 50 baud, use the 2 Command to
switch speeds.
Baudot code–The modem uses Baudot
code only. The 2 Command determines
whether it uses 45 baud or 50 baud.
ASCII code–The modem uses ASCII
code only. The 3 Command determines
whether it uses 110 baud or 300 baud.
2–Baudot speed (The default is 45
baud)
This command has two settings: 45
baud and 50 baud.
45 baud–When the modem is using
Baudot code, it sends and receives at
the rate of 45 baud.
50 baud–When the modem is using
Baudot code, it sends and receives at
the rate of 50 baud.
3–ASCII speed (The default is 300
baud)
This command has two settings: 110
baud and 300 baud.
110 baud–When the modem is using
ASCII code, it sends and receives at
the rate of 110 baud.
300 baud–When the modem is using
ASCII code, it sends and receives at
the rate of 300 baud.
O–Originate/Answer (The default is
Answer mode)
This command has two settings: Origi-
nate and Answer. It applies only to
ASCII code communication. It has no
effect when using Baudot code.
Originate–When the modem is using
ASCII code, it sends out an ASCII
originate tone.
Answer–When the modem is using
ASCII code, it sends out an ASCII
answer tone.
F–Half- or Full-duplex (The default is
Half-duplex)
This command has two settings: Half-
duplex and Full-duplex. When you type
a letter or number on your computer,
this command determines how that
character is displayed on the screen.
Half duplex–When the code for a typed
character is sent to the modem, the
modem sends it to the other computer
or TTY and also sends it back to your
computer for display on the screen.
Full duplex–The Intele–Modem sends
the character code to the other
computer or TTY only. It’s the
responsibility of the other computer to
send the code back for display on your
screen.
This command is useful if you get
double characters on your screen. You
can set the F Command to full- or half-
duplex in both ASCII and Baudot
codes. For more information, see the
Problems and Solutions section on
page 21.
E–Echo on/off (The default is Echo On)
This command has two settings:
Character Echo On and Character
Echo Off. It determines whether the
letters you type to issue commands to
the modem appear on the screen or
not. It has no effect in on-line mode.
Character Echo On–When you type a
command, it is displayed on the screen.
Character Echo Off–When you type a
command, it is not displayed on the
screen.
THE INTELE-MENU COMMAND SET • 11
Communication Settings _____________________________________