Uniden 7000A - Manual (Page 37)

TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM SUGGESTION
Answering system does not work • Make sure the telephone line cord
is plugged in.
• Make sure that the AC Adaptor
is plugged in.
• Make sure the DTAM is turned on.
• There has been a power failure.
Disconnect the telephone line cord,
press the reset button and re-connect
the telephone line cord.
Answering System does not answers • The memory may be full. Delete some
after 3 rings. or all of the saved messages.
Messages are incomplete. • The incoming messages may be too long.
• The memory may be full. Delete some
or all of the saved messages.
No sound on the base unit speaker during • Adjust the volume control on the side of
call monitoring or message playback. the DTAM. Refer page 27
Cannot record outgoing message (OGM) • The memory may be full. Delete some or
all of the saved messages.
37
If your 7000A DTAM unit is not performing to your expectations, please try these
simple steps. If you are still unable to resolve the problems, contact Uniden
Customer Service for assistance.
New Zealand: 0800 4 UNIDEN Australia: 1800 632 789
4 864336
Continued over....