Uniden DCT 748 - Manual (Page 10)

[ 9 ] G E T T I N G S T A R T E D w w w . u n i d e n . c o m
C. Connect the base unit and charge the handset
1) Connect the AC adapter to the DC
IN 9V jack and to a standard
120V AC wall outlet.
Note:
• Connect the AC adapter to a
continuous power supply (i.e., an
outlet that is not controlled by a
switch).
• Place the base unit close to the
AC outlet to avoid long extension cords.
2) Place the handset in the base unit with the keypad facing forward.
3) Make sure that the charge LED illuminates.
If the LED does not illuminate, check to see that the
AC adapter is plugged in and the handset makes
good contact with the base charging contacts.
4) Charge your handset at least 15-20 hours before
plugging into the phone line.
5) Once the handset battery pack is fully charged,
connect the telephone line cords to the TEL LINE
jack and to a telephone outlets.
If your telephone outlet isn't modular,
contact your telephone company for
assistance.
•Use only the supplied
AD-800 AC adapter.
Do not use any other
AC adapter.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
note
GE
TTING ST
ARTE
D
UP720.book Page 9 Tuesday, July 6, 2004 10:55 AM