Beep alert, Programming tips, Deleting a stored frequency – Uniden BC780XLT User Manual

Page 30: Service search public safety

Advertising
background image

22

Beep Alert

The scanner can alert you with three rapid beeps at the beginning of a transmission on an
assigned frequency.

Assigning the beep alert to a channel

This alert can be set on/off to every channel (or to every ID memory for Trunking mode).

1. Press MENU.

2. Press

▲ or ▼ to select CH DATA and then press E.

3. Select the channel number to be tagged using

▲ or ▼ and then press E. (You can also

enter the channel number in using the keypad or VFO control and then press E.)

4. Press

▲ or ▼ to select BEEP ALERT and then press E.

5. Press

▲ or ▼ to select ON or OFF and then pressing E.

Note: If NOT REGISTER appears, make sure a frequency is stored in the channel.

Programming Tips

• Do not program a weather frequency into one of the channels, since weather channels

transmit continuously. Use the Weather Search feature to select the weather information band.

• Group similar services into a bank. For example, program police frequencies in channels 1

through 10 and fire/emergency into channels 51 through 60, and so on.

• Put the frequency that you listen to the most or the most important frequency into a

Priority channel.

• To quickly program a series of channels, start with the lowest number channel.

For example, when you are programming five new frequencies into Channels 4 through
8, start with Channel 4. After you finish programming a channel, press MAN or HOLD/

to go to the next higher channel.

• Write down your programmed channels and frequencies and put in a convenient place in

case of accidental reprogramming.

• Frequencies are rounded off according to the step of each channel.

• When you are overwriting a tagged channel with a new frequency, the previous alpha tag

will be deleted. You must re-enter the alpha tag.

• When programming frequencies, a 2 second delay is set automatically but can be

changed in the Channel Data menu.

Deleting a Stored Frequency

To delete a stored frequency:

a. Select a channel.
b. Press 0.
c. Then press E.

Note: Channels with no frequencies are automatically locked out.

SERVICE SEARCH
PUBLIC SAFETY

Advertising