Universal Remote Control (URS) POWERBLASTER MRF100B - Manual (Page 2)

PowerBlaster
TM
WELCOME
1
PowerBlaster
TM
WELCOME
2
Congratulations!
Congratulations on purchasing
Universal Remote Control’s
PowerBlaster
TM ‚ MRF100B!
This changes everything!
When used in combination with
PowerBlaster
TM , a MasterControl TM
RF series remote control (RF10,
RF20, RF30) becomes an amazing
remote control powerhouse that
sends multi-directional RF (Radio
Frequency) signals that pass
through walls, doors and floors-
both indoors and outdoors.
PowerBlaster TM sets you free!
It enables you to control
Components that are completely
out-of-sight, up to 100’ away. The
PowerBlaster
TM picks up RF
remote control radio frequency
signals from any direction,
regardless of distance, so the
remote doesn’t need to be pointed
directly at any Component. Just
imagine - no more pointing! Now
you can close your entertainment
center doors, hide your
Components, and still control
them with ease. Control outdoor
speakers on your patio. Control
your Components anywhere!
RF Remotes are ready to go!
One of the best things about this
is - nothing has to be done to
the remotes themselves for this
feature to work. Every time you
press a button on one of the
MasterControl
TM RF series
remotes, it sends both a standard
IR (Infrared Command) AND an
RF (Radio Frequency) signal.
When you install the PowerBlaster
TM
kit, it will automatically receive radio
signals from RF series remotes and
translate them into the infrared
commands that control your
Components.
Quick Setup DVD Guide makes
installation easy!
The Quick Setup DVD Guide will
assist you in setting up
PowerBlaster
TM to work with your
RF series remotes by guiding you
through an easy step-by-step
process. This Owner’s Manual is
designed as a companion refer-
ence source to the DVD Setup
Guide, should you need to refer
back to a particular section, or
review certain instruction detail
not covered in the DVD. However,
if you are unable to watch the
DVD Guide for some reason,
everything you need to know
about setting up PowerBlaster
TM
is contained in this Manual.
NOTE: PowerBlaster TM is only
compatible with Universal
Remote Control’s MasterControl
TM
RF series remote controls (RF10,
RF20, RF30). RF series remote
control radio signals will not
control Components directly.You
must have a PowerBlaster
TM to
receive the RF remote radio
signals. Also, Components that
came with "no pointing" radio
remote controls cannot be
operated by an RF series remote
unless the Component can be
switched to standard IR (Infrared
Control) via its internal menus.
Some remote control ceiling fans
are radio only and cannot be
operated by an RF series remote.
POWERBLASTER TM Owner’s Manual
© 2006 Universal Remote Control, Inc.
The information in this manual is copyright protected. No part of this manual may be
copied or reproduced in any form without prior written consent from Universal
Remote Control, Inc. UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE
FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS / OMISSIONS MADE IN
THIS MANUAL. The information in this manual may be subject to change without
prior notice. MASTERCONTROL, PowerBlaster, MacroPower, and SimpleSound are
trademarks of Universal Remote Control, Inc. All other brand or product names are
trademarks or registered trademarks of their respective companies or organizations.
500 Mamaroneck Avenue, Harrison, NY 10528
Phone: (914) 835-4484 Fax: (914) 835-4532