Unitech MP300 - Manual (Page 13)

Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
24
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
25
Magnetic Stripe Reader Commands (When MSR is Installed)
Command String Printer Action
ESC - ‘M’ - ‘nnm’ - Cr
Select MSR with (nn) auto timeout Where
nn=”00” to “99”
m=1: Reads track 1 only
m=2: Reads track 2 only
m=3: Reads track 3 only
m=4: Reads track 1 & 2
m=5: Reads track 2 & 3
m=6: Reads track 1, 2 & 3
ESC – ‘C’ Cancel MSR read process
Smart Card Reader Control Commands (when SCR is installed)
Command String Printer Action
ESC - ‘M’ - ‘nn’ - ‘7’- Cr
Select SCR in direct mode with Serial RS232
(UART0). (nn) is the auto timeout of the SCR.
ESC - ‘M’ - ‘nn’ - ‘8’- Cr
Select SCR in PassThru mode with BT or IrDA
on (UART1). (nn) is the auto timeout of the SCR.
Graphic Logo and Bar Code Commands
Command String Printer Action
ESC - L - G - n Prepare printer to load image
ESC - G - 0x0FF Loading logo complete
ESC - L - g - n Print stored logo image
ESC - ‘z’ - n1 - n2 - L - [data] Print bar code without visible text
ESC - ‘Z’ - n1 - n2 - L - [data] Print bar code with visible text
ESC - ‘Q’ - ‘J’ - n Reverse dot feed
ESC - ‘Q’ - ‘Q’ - n Set out of paper sensitivity
ESC - ‘Q’ - ‘F’ - m Set forward black mark seek
ESC - ‘Q’ - ‘B’ - m Set reverse black mark seek
Printer Supervisory and Control Commands
Command String Printer Action
^V Buffer, power timer and battery status
^B Buffer status
ESC - ‘P’ - ‘^’ Print battery voltage
ESC - ‘M’ - ‘000’ - Cr Disable the power down timer
ESC - ‘M’ - ‘nn0’ - Cr Sets the power down timer to nn seconds
ESC - ‘M’ - ‘C’ Reset auto power down to 20 seconds
ESC - ‘P’ - ‘(‘ Firmware version query
ESC - ‘P’ - ‘)’ Hardware model query
ESC - ‘P’ - ‘+’ or ‘-’ Enable or disable EOT printer response