Uniden 4541 - Manual (Page 4)


B. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack. The
battery recharges automatically when the handset is placed in
the base unit.
NOTE: If your home has specially wired alarm
equipment connected to the telephone line, be sure
that installing the system does not disable your
alarm equipment. If you have questions about what
will disable your alarm equipment, contact your
telephone company or a qualified installer.
1) Press down on the handset battery case cover (use the
finger indention for a better grip) and slide the cover
downward to remove.
2) Plug the battery pack connector (red & black wires) into
the jack inside the battery compartment (the connector
notches fit into the grooves of the jack only one way).
Match the wire colors to the polarity label in the battery
compartment, connect the battery and listen for a click to
insure connection.
3) Fit the battery pack into the battery compartment.
4) Before replacing the battery cover, pull on the battery
wires slightly. If the connection is secure, the jack will stay
in place. Then place the battery case cover back on the
handset by sliding it upwards until it clicks into place.
NOTE: For optimum performance, use only the
Uniden Battery (BT- 007) supplied with your phone.
C. Connect the base unit and charge the handset
1) Connect the AC adapter to the DC IN 9V jack
and a standard 120V AC wall outlet.
2) Set the base unit on a desk or tabletop, and
place the handset in the base unit with the
keypad facing forward.
3) Make sure the in use/ LED illuminates. If the
LED does not illuminate, check to see that
the AC adapter is plugged in and the handset
makes good contact with the base charging
contacts.
NOTICE: Do not place the power cord
where it creates a trip hazard or where
it could become chafed and create a fire
or electrical hazard.
NOTE:
• Use only the supplied AD-000 AC
adapter. Do not use any other AC
adapter.
• Connect the AC adapter to a
continuous power supply.
• Place the base unit close to the AC
outlet to avoid long extension cords.
4) Charge your handset at least 15-20 hours
before plugging the phone line.
5) Once the handset battery pack is
fully charged, connect the telephone
line cord to the TEL LINE jack and
a telephone outlet. If your telephone
outlet isn’t modular, contact your
telephone company for assistance.
Route the cord.
Route the cord.
Route the cord.
Route the cord.
Modular Modular