Unibrain 830 - Manual (Page 58)

Unibrain Fire-i 530/630/830 Operation Manual Page 52
4.9.3. SIO(RS232) Special Commands
0xF2F10018
Auto-Sync Mode control register
Bit 31 : auto sync enable
Bit 30 : SIO enable mode (0 : Custom mode, 1 : IIDC v1.31)
Bit 27 : auto sync complete (read only. 1: ready, 0: not yet auto-sync)
Read/Write
Custom commands are valid when the Bit30 is to be set “0”(zero).
SIO(RS232) custom commands are non IIDC compliant which is a specific mode for the cameras.
Before using these commands serial communication parameters must be set at Serial_Mode_Reg(F2F22000h)
F2F10018 means that the RS232 command is valid.
Baud Rate Stop Bit Parity Flow Control
57600 bps (default) 1 bit None Non
 Command format : [STX] [Command] [Data] [ETX]
[STX] : Command start character : ‘S’
Command] : Command length is 2byte. See next page command table.
[Data] : Data length is varied with each command. Data format is hexadecimal: ‘0’~’9’, ‘A’~’F’.
[ETX] : Command end character : ‘Z’
 Return value
‘ G’ : Command complete acknowledge.
“ Gdd..d” : “dd..d” is return data and hexadecimal character.
‘ U’ : Undefined command.
 Valid Character: ‘0’~’9’, ‘A’~’F’, ‘S’,’Z’ Invalid character is received is discarded.
 Example: Gain setting command with 0x200 value.
All of “SA0200Z”, “S A0 200 Z”, “SA0 200Z”, “S A0200 Z”, and “SKA0V200Z” are parsed to
“ SA0200Z Z”, and “SKA0V200Z” are parsed to “SA0200Z”.
 SIO(RS232) Commands
STX Command
Data
Length
ETX
Return
Value
Function
S A0 3Bytes Z G
Gain control (0x000 ~ 0x30F(BW Model) or 2D3(Color Model))
(see gain mapping graph)
Ex) SA0200Z : Gain index value 512 (18dB)
S A1 3Bytes Z G
Shutter speed control
(0x001 ~ 0xCFB) (see shutter speed table)
S A2 1Bytes Z G
Set/Clear auto shutter speed and auto gain
Bit 0 : Auto gain Bit 1 : Auto shutter speed
Ex) SA21Z : set auto gain and clear auto shutter speed
SA23Z : set auto gain and auto shutter speed
SA20Z : clear auto gain and auto shutter speed
S A3 2Bytes Z G Auto exposure control (0x00~0x64)
S A4 1Bytes Z G Gamma control (0x0~0x19) (see gamma table)
S A5 3Bytes Z G Brightness control (0x000~0x800)
S A6 3Bytes Z G Sharpness control (0x000~0x3F8)
S A7 1Bytes Z G ISO control 1: ISO enable, 0 : disable
S A8 1Bytes Z G Trigger control 1: trigger enable, 0 : trigger disable