Uniden BT229 - Manual (Page 5)

5
Make sure the headset is powered off and the power adapter is not connected (you can’t use the
headset while it’s charging).
Press and hold
MFB until the LED flashes alternating red and blue (approximately 6 seconds),
then release. The headset is in pairing mode and should be visible to other Bluetooth devices.
On your phone, start a search for Bluetooth headsets or handsfree devices. (This process may
take several seconds, and it will be different for each phone; see your phone’s manual for
detailed instructions.)
Your phone should discover a device called a BT229 or BT229 headset, When your phone asks if
you want to pair with this device, answer yes.
When your phone prompts you for a PIN code or password to pair with the BT9 enter
0000 .
When the headset is paired, the blue LED flashes twice every 5 seconds; your phone might also
display a confirmation message.
If the blue LED flashes once every 5 seconds, the headset is
not paired. Try the pairing procedure again.
1)
)
)
)
5)
6)