Uniden UBCT9 User Manual
Page 58
54
If you experience difficulty while in TrunkTracker mode, try the following steps.
Problem
Suggestion
Scanner won’t track.
1. Missing the Data Frequency.
2. Change to a Type 1 Scanner setup.
Review Fleet Map Programming on page 44.
Scanner won’t stop
during Scan List
mode.
1. No IDs have been programmed.
2. The IDs you have stored are not active.
Scanner will not
acquire
data channel.
1. Adjust the squelch for Trunking mode - refer to page 29.
2. Missing the frequency used for the data channel.
Check your frequency list.
Missing replies to
conversations.
1. Change a Type 1 scanner setup.
Review Fleet Map Programming on page 44.
2. Try another Preset Fleet Map or Program your own Fleet
Map.
3. Check to see that all of the system’s frequencies have
been entered.
Channel Activity
Indicators are flashing
but no sound is heard.
1. May be a telephone interconnect call, which are
intentionally blocked by your scanner.
2. The ID on your display is not active.
Scanner not tracking
an EDACS system
properly.
1. Logical channel numbers (frequencies) for the system are
not programmed in the correct order. Check frequency
resources and reprogram.
2. Not all frequencies for the system are programmed.
Check frequency resources.
If you still cannot get satisfactory results while using your scanner or if you want additional
information, please see the Uniden contact details in the warranty page at the back of this
manual.
If you have internet access, you can visit www.uniden.com.au, www.uniden.co.nz for
additional information.
UBCT9 OM 54
12/11/07 3:54:05 PM