Uniden CEZ200 - Manual (Page 4)

Wall-Mounting the Phone
You can mount the phone on
any standard telephone wall
plate where the pins are 100
mm (3 15 /
16
inches)
apart.
Before
putting the
handset in
the cradle,
you need to
switch the
handset
clip into
wall mount
mode as
shown in
the drawing
below.
Solving Problems
If you have any trouble with your phone, try these simple steps first.
If you still have a question or problem, call the Customer Hotline
listed on the front page.
Problem Things to try
I keep hearing a dial tone
when I try to make a call.
Checking the Tone/pulse switch: if it’s on
tone, change it to pulse and try again.
The phone rings, but I can't
hear anything.
Checking the coiled cord connection
between the base and the handset.
Connect the cords as
usual, but route the
line cord through
the inside channel.
Line up the notches on the
base with the pins on the
wall plate. Place the phone
over the plate and slide it
down to lock it into place.
Tuck excess line cord into the
space on the back of the phone.
Connect the cords as
usual, but route the
line cord through
the inside channel.
Line up the notches on the
base with the pins on the
wall plate. Place the phone
over the plate and slide it
down to lock it into place.
Tuck excess line cord into the
space on the back of the phone.
Flip the clip from
front to back.
Slide the
clip out of
its slot.
Rotate the clip
180 degrees.
Slide it
back into
the slot.
Flip the clip from
front to back.
Slide the
clip out of
its slot.
Rotate the clip
180 degrees.
Slide it
back into
the slot.