Unwind DT-920 - Manual (Page 5)

DIRECT TUNING
1. Press the BAND button to select AM or FM.
2. Press the DIRECT IN button.
"FM ---. -- MHz" or "AM - - - - kHz" appears and blinks.
3. Press the PRESET buttons (1 - 0) to enter the frequency
of a broadcast station.
Example:
FM 98.1 MHz... Press 9, 8 and 1.
FM 103.5 MHz... Press 1, 0, 3 and 5.
AM 560 kHz... Press 5 and 6.
AM 1680 kHz... Press 1, 6 and 8.
NOTE:
If you try to enter an incorrect station frequency (86.0MHz
or 500kHz, for example), the display will continue to blink
until the correct number is entered.
AUTOMATIC OR MANUAL PRESET TUNING
Automatic preset tuning (APT) Manual preset tuning
1. Press the BAND button to select AM or FM.
2. Press the SCAN LEVEL button to select the desired
scan level, "SCAN 1" or "SCAN 2."
3. Press and hold down the MEMORY button for at least 3
seconds, until "APT" and "CH" blink, then release the
button.
The unit will start at the low end of the selected band and
scan upward (higher frequency numbers). Up to 20
stations will be memorized automatically.
After the last station is programmed, the lowest preset
station number will be selected. "APT" disappears.
4. To automatically preset stations on the other band,
press the BAND button, then follow steps 1 - 3 above.
IMPORTANT NOTE
- If APT is activated, all previously programmed stations
will be cleared and new stations will be programmed.
- FM stations will be automatically programmed into CH01
- CH20.
AM stations will be automatically programmed into
CH21 - CH40.
1. Press the BAND button to select AM or FM.
2. Tune in a station as described in "FREQUENCY UP/
DOWN TUNING" or "DIRECT TUNING."
3. Press the MEMORY button. "MEMO" appears and
"CH - -" blinks.
4. Press two PRESET buttons (1 - 0) while "CH - -" is
blinking.
When presetting stations, two buttons must be pressed
(except when presetting CH40).
Example:
CH01 ....... Press "0" and "1".
CH05 ....... Press "0" and "5".
CH12 ....... Press "1" and "2".
CH39 ....... Press "3" and "9".
CH40 ....... Press "4" only.
The selected station is now programmed. The preset
channel number and the frequency of the programmed
station appear on the display.
NOTES:
- You cannot enter preset numbers above CH40.
- If a new station is programmed into a band and
preset number already containing a programmed
station, the previously programmed station will be
cleared.
5. To manually preset stations on the other band, press
the BAND button, then follow steps 1 - 4 above.
-4-