Universal Electronics PVR 5 - Manual (Page 15)

15
PROGRAMMING CHANNEL CONTROL LOCK
By default, the remote control’s channel-control capabilities
are locked to the cable converter. The affected keys* are
0 ~ 9, CH+, CH-, ENTER, and LAST. This will guarantee that
you do not inadvertently change a channel on your TV or
VCR. However, you can de-activate this feature to allow full
access to these keys in the TV and VCR modes.
*NOTE: This feature does not affect the AUD mode.
To De-Activate Channel Control Lock:
1. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2. Enter 9 -7- 3. The CBL key will blink twice.
3. Press CH- once. The CBL key will blink
four times.
4. Now, the remote control will provide TV and
VCR channel-control capabilities while in the
TV or VCR mode.
To Re-Activate Channel Control Lock:
1. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2. Enter 9 -7- 3. The CBL key will blink twice.
3. Press CH+ once. The CBL key will blink twice.
4. Now, regardless of what mode you select
(except AUD), only the channel control
capability of your cable converter will be
accessible.
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 15