Univex SRTZ2401-CA - Manual (Page 20)

20
6. Set up
English
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you. (SE1)
(1) About 19 inches (48cm)
■ ATTACHING THE TRIMMING MECHANISM (SE2)
1. Remove the screw screwed into the end of the
trimming mechanism.
2. Insert the end of the trimming mechanism into the
main pipe.
3. Line up the hole on the end of the trimming
mechanism into which the screw is to be inserted
with the hole on the main pipe, and screw the screw
firmly in.
4. Using a 10-mm wrench, screw in the hexagonal bolt
provided to fix the trimming mechanism into place.
(1) Main pipe
(2) Trimming mechanishm
(3) Screw hole
(4) Screw
(5) Fastening bolt
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Depending on the working posture, slide clamp up or
down until unit balances and the strap fits your body.
(1)
SE1
(5)
(4)
(3)
(2)
(1)
SE2