Univex ProSafe WFS709TP - Manual (Page 24)

WFS709TP ProSafe Smart Wireless Switch Hardware Installation Guide
2-4 Installing the Chassis
v1.0, May 2007
For best operation, keep the WFS709TP and all cords and cables at least 0.7 meters (2 feet)
from fluorescent lighting fixtures, and 2 meters (6 feet) from photocopiers, radio transmitters,
electric generators, and other sources of strong electromagnetic interference. See also
Appendix B, “Specifications” .
Mounting the Chassis
This section provides instructions for installing the WFS709TP ProSafe Smart Wireless Switch.
1. Make sure that your rack environment meets the installation requirements listed on page 2-3 ).
2. Attach the WFS709TP to the rack, as described in the following section
• Position the chassis in the equipment rack and align the brackets’ mounting holes with the
corresponding holes in your rack frame (
Figure 2-1 on page 2-5 ).
Warning: To avoid personal injury or damage to equipment, get help in lifting and
positioning the WFS709TP. Also, do not install the WFS709TP where
instability or uneven mechanical loading may occur.
Note: For proper operation, make sure your rack environment is in compliance with
the operating temperatures described in Appendix B, “Specifications” .