Uniden DSS7805 - Manual (Page 3)

Installing Your Expansion Handset
Follow these three easy steps to get your new handset ready to use:
Install the battery pack.
Connect the charger and charge your new handset for 15-20 hours.
Register your new handset to the main base unit.
Press down on the handset battery case cover
(use the finger indention for a better grip) and
slide the cover downward to remove.
Plug the battery pack connector (red & black
wires) into the jack inside the battery
compartment. (The connector notches fit into the
grooves of the jack only one-way.) Match the
wire colours to the polarity label in the battery
compartment, and push the connector in until
you hear a click.
Make sure you have a good connection by
slightly pulling on the battery wires. If the
connection is secure, the battery jack will remain
in place.
Place the battery case cover back on the
handset by sliding it upwards until it clicks into
place.
Place the handset in the charging cradle with
the keypad facing forward.
•
Replacement batteries are also
available. Visit our web site at
www.uniden.com.au or
www.uniden.co.nz.
• Recharge your handset on a regular
basis by returning the handset to the
charger after each phone call.
Rechargeable Nickel-Metal-Hydride
Batteries Must Be Recycled or
Disposed of Properly
1
2
3
1
2
3
4
5
Step 1: Install the Battery Pack
Use only the Uniden battery (BT-446)
supplied with your phone.
(2)