Uniden ANA 9610 - Manual (Page 26)

Charging Spare Battery Packs
The Charger Unit of your ANA 9610 is equipped to charge the
Spare Battery Pack with or without the Handset in the front slot.
1. Slide the Spare Battery Pack
into the second slot in the
Charging Unit until the
retaining clip snaps over the
top of the pack.
2. Make sure the CHARGE 2
indicator lights. If the
CHARGE 2 indicator doesn’t
light, check to see that the AC
Adapter is plugged in, and that
the Battery Pack is making
good contact with the
Charging Unit charging
contacts.
Note: Charge the Battery Pack without interruption for 8 hours.
3. When charging is complete, press out on the latch and remove
the Battery Pack for use. Or, if you don’t need the Battery
pack immediately, leave it in the Charging Compartment; it will
not overcharge.
Low Battery Indicator
When the Battery Pack in the
Handset is low and needs to be
charged, you will see a message
on the display.
On a Call In Standby Mode
Only the talk button operates. None of the buttons operate.
Handset beeps once every 3 seconds Handset beeps every 15 seconds for
15 minutes.
Complete your call as quickly as
possible Cannot make call.
Replace Battery pack within 20
seconds to continue call. Replace Battery Pack before making a
call.
Return the Handset to the Charging Unit for charging or replace the
Handset Battery Pack with another charged Battery Pack.
20
batt low
P:\ana9610e\9610usae.vp
Mon Aug 30 10:26:16 1999
Color profile: Disabled
Composite Default screen