Uniden TRU 8885 SERIES User Manual
Page 32
G E T T I N G S T A R T E D [ 3 1 ]
w w w . u n i d e n . c o m
Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system, set the unit to tone dialing. Make a trial call. If
the call connects, leave the setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to “Tone Dialing
Switch-over” on page 38).
1) Enter the Global Setup menu, and then the Dial Mode
submenu (see "Entering the Menu" on page 16).
2) Press
volume up/down to select
T one
or
Pul se
(the
initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
& K C N / Q F G
6 Q P G
2 W N U G
$#%-
& ' . ' 6 '
1-
G
E
TTIN
G
S
T
AR
TE
D
TRU8885_1st.book 31 ページ ２００４年１月７日 水曜日 午後６時３９分