Uniden 250 - Manual (Page 12)

Charging the Battery Pack
Your marine radio is powered by a specially designed Ni-MH bat-
tery pack.
• Before operating the ATLANTIS 250, charge the Ni-MH battery
pack for 16 hours without interruption with the Adaptor.
1 Place the ATLANTIS 250 in
the Cradle.
Make sure your radio is OFF.
2 Plug one end of the AC adaptor into the wall
outlet and the other end into the Adaptor jack
on the back of the ATLANTIS 250.
3 Charge the battery for 16 hours.
• The charger will not overcharge the battery pack. After 16 hours
without interruption, charging is completed.
• Be sure to replace the rubber cap after charging in order to
secure the splashproof seal.
• The radio will not charge the battery while on and receiving
incoming voice traffic.
• When you mount the Cradle on your boat, use the DC adaptor
instead.
• The jack is for charging only. If the battery level is low, the radio
needs to be charged before use.
10