United States Stove Company 5510 - Manual (Page 4)

4 USSC
Specifications
Heat Output 1 48,000 BTU/hr.
Heating Capacity 2 800 - 2,000 sq. ft.
Fuel Burn Rate 3 2.0 - 6.0 lbs./hr.
Burn Time (lowest setting) 60 hrs.
Hopper Capacity 150 lbs.
Heating Specifications
Height 34 in.
Width 26 in.
Depth 25 in.
Weight 250 lbs.
Dimensions
1 BTU output will vary depending on the quality of fuel. Use PFI listed fuels for the best results.
2 Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside temperature.
3 Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%. Use PFI listed fuel for best results.
Electrical Rating 110-120 volts, 60 HZ, 3.0 Amps
Watts (operational) 175 (approx.)
Watts (igniter running) 425 (approx.)
Electrical Specifications
FuEL CONSidErATiONS
Your Pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel Industries
standards. (Minimum of 40 lbs density per cubic ft, 1/4” to 5/16” diameter, length no greater than 1.5”, not less than
8,200 BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). Pellets
that are soft, contain excessive amounts of loose sawdust, have been, or are wet, will result in reduced performance.
SAFETy ANd EPA COMPLiANCE
Your Pellet stove has been safety tested and listed to ASTM E 1509, (UM) 84-HUD by OMNI-Test Laboratories, Inc.
Portland, Oregon, USA. It is also certified and tested to EPA Phase II requirements.