UltraViolet Devices UVA User Manual
Page 7
Ultra-Lum, Inc. 1480 N. Claremont Blvd. Claremont, Ca. 91711-3538
www.ultralum.com
81-0008-01 REV A
7
2.6
Handheld Lamp Controls Defined
1.
AC Mains power switch.
2.
AC main power switch and Lamp selector for Dual Wave devices
3.0 Operating
Instructions
3.1
Operating the Handheld Ultraviolet Lamps
3.1.1
This device is provided with an adjustable strap to allow the user to hold on to the lamp.
3.1.2
The Handheld Lamps have been designed to operate using one of the following Voltages:
100 VAC, 115 VAC, or 230 VAC line from 47 to 63 Hz. Refer to the Ratings label located
near to the AC line cord entry point.
3.1.3
Plug the Handheld lamp into the appropriate AC line power receptacle.
3.1.4
Ensure that both the product user and any personnel in the area are adequately protected
from ultraviolet radiation. See the Safety Precautions section 2.1 of this manual for further
information.
3.1.5
Turn on the Handheld lamps AC main power switch. The switch will illuminate green and the
UV lamps should light. There is a warm up period of approximately 5 minutes for the UV
lamps to reach maximum intensity. The Handheld lamp is now ready for use.
1
2