Connecting to a chartplotter, Connecting to an external speaker – Uniden Waterproof DSC Marine Radio UM380 User Manual

Page 37

Advertising
background image

33

English

Follow the steps below to adjust the time:

1. Display the normal menu and choose the Setup sub-menu.

2. Select GPS Setup and then choose Time Adjust.

3. The display shows your current local time. To adjust the time forward one hour, use

CHANNEL UP

. To adjust the time back one hour, use

CHANNEL DOWN

button. Press

ENT-

1W/25W

button when you are finished.

4. The display prompts you to confirm the setting: choose Set to save the new time or

Cancel to exit time setup without saving. The radio returns to the GPS Setup menu.

5. If your local area observes Daylight Savings Time, choose Daylight Save and press the

ENT-1W/25W

button.

6. If Daylight Savings Time is currently in effect, select On. If Daylight Savings Time is not

currently in effect, select Off.

7. Press

ENT-1W/25W

. The radio activates the new time setting and returns to the GPS Setup

menu.

Connecting to a Chartplotter

Your radio provides a standard NMEA0183 GPS output that you can connect to a

chartplotter. When it receives another boat’s position data in a DSC call, the radio sends the

position data to the chartplotter so you can see the location:

1. Connect the ORANGE wire of the accessory cable to the NEGATIVE (-) wire of your

chartplotter’s NMEA data INPUT.

2. Connect the YELLOW wire of the accessory cable to the POSITIVE (+) wire of your

chartplotter’s NMEA data INPUT

3. Be certain all wire connections are secure and that all open wires are adequately

covered.

#

nOte: to extend the life of the radio, use waterproof tape to seal electrical connections.

Connecting to an external Speaker

You can use an external speaker to monitor the radio from a different part of your boat or in

a noisy environment. If you adjust the

VOLUME-PWR

knob on the radio, it will also adjust the

external speaker volume.
Your radio supports an external speaker with the following specifications:

x

Minimum impedance of 4 Ohms

x

Minimum power handling of 10 Watts

1. Connect the BLACK wire of the accessory cable to the GROUND WIRE of your external

speaker.

Use the up and down arrows

to adjust the time by

one hour.

16

Back[CLR] Select[ENT]

Time Adjust

09

: 14

Setup

Press and hold -

GPS Setup

Time Adjust

UM380_20101221.indd 33

4/13/2011 11:25:18 AM

Advertising
This manual is related to the following products: