U-Line 2275ZWC - Manual (Page 17)

2275ZWC & 2275ZWCOL 15
NOTE: 38°F is an example; the display will vary with actual set-point.
IMPORTANT
Factory recommended set-points are: 55°F top zone, 50°F bottom zone. Whenever a zone range is changed
(example: RW to WW), it will revert to the factory default. To change the set-point for the new range, refer
to ADJUSTING SET-POINT TEMPERATURE.
14 ELECTRONIC QUICK CONTROL
GUIDE
Task Touch Touch Display Comment
Turn ON/OFF Hold 10 seconds Release when unit beeps. or
Adjust
Set-Point
Temperature
Touch and
release desired
zone warmer
icon
then
Touch and
release the
light icon
or
Touch to change
temperature
Zone range is displayed after
first touch, set-point
displayed after touching
LIGHT icon. Set-point saved
after 5 seconds of inactivity.
View Actual
Temperature
Hold 5 seconds
for desired zone
Release when unit beeps.
After 5 seconds, display
returns to set-point display.
Change °F-°C Hold or
Repeat to switch back.
Blackout
Mode
Hold 10 seconds
Display (and cabinet light) not
operable in Blackout Mode.
To cancel, repeat steps.
Cabinet Light Press and release
Light normally goes on/off
with door opening. Pressing
light button will turn
interior light on for 4 hours,
then it will turn off.
Display Off
Mode
Hold (left display)
Display off when door is
closed (unless cabinet light is
switched on). Repeat to
switch back.