ViewEra V152 - Manual (Page 7)

AUTO
－
＋
Pow e r
LED Ind i ca tor
5
Fig .4 Fig.3
2.2 Signal cable connection
or DVI lock f Plug one connector of the signal cable into the VGA port and the two bolts to ensure irm
grounding.Then plug the other one into the monitor and lock the two bolts.
Plug one side of the power cord into the AC adapter and the other side into AC power source outlet, then plug
the output side of the AC adapter into the power port at the side of monitor.
Plug one side of the audio cable into the PC audio port, then plug the other side into the audio port of the
monitor.
Switch on the power to both the monitor and your computer.After the monitor is power on,the LED lights up
green or blue. If the LED becomes red and flashing, please check the video signal cable connection.If the
LED is off, please press power switch slightly.
If there is no horizontal or vertical sync.signal, your monitor will display Fig.3 to Indicate no signal input.After
a few seconds, the monitor will come into waiting and saving power mode;if the monitor receives the video
signal,it will return to the normal mode.
2.3 Power cord connection
2.4 Audio cable connection
2.5 Power on
2.6 Self test pattern