VocoPro UHF-3800 - Manual (Page 6)

Microphone Placement & Tone Quality
Lead & Backup Vocals
Lips should be less than 3" from or even touching the windscreen on an axis to the microphone.
Doing this creates a robust sound, emphasizes bass and provides maximum isolation from
other sources.
Speech
When giving a speech or simply speaking, place the microphone 4" to 10" away from the mouth, just
above nose height for a natural sound with reduced bass. You can also place the microphone
8" to 16" away from the mouth, slightly off to one side, for a more "distant" sound with highly
reduced bass and minimal "s" sounds.
Microphone Position
The UHF-3800 is ideal for close-up vocals and can be held in the hand or mounted on a mic stand.The
most common applications and placement techniques are listed below. Keep in mind that microphone
technique is largely a matter of personal taste, there is no one "correct" microphone position.
Proximity Effect
When the sound source is less than 1/4 in. from the microphone, the microphone boosts bass
frequencies (by 6 to 10 dB at 100 Hz), creating a warmer and richer bass sound than when farther
away. This effect, known as proximity effect, happens only in unidirectional dynamic microphones
like the UHF-3800.
Feedback
Feedback occurs when the amplified sound from any loudspeaker reenters the sound system through
any open microphone and is amplified again and again and again. Most commonly, feedback is caused
by the following conditions: placing loudspeakers too close to microphones, having too many open
active microphones, boosting tone controls indiscriminately (mainly treble) and performing in areas
with high ratios of room surfaces that have hard and reflective surfaces such as glass, marble and
wood. What to do if feedback occurs before the sound system is loud enough?
• Request that the talker speak louder into the microphone.
• Reduce the distance from the talker to the microphone. Each time this distance is halved, the sound
system output will increase by 6dB.
• Reduce the number of open microphones.
• Move the loudspeaker farther away from the microphone. Each time this distance is doubled, the
sound system output can be increased by 6dB.
• Move the loudspeaker closer to the listener.
• Use an equalizer/feedback reducer to cut the frequency bands in which the feedback occurs.
Microphone Basics
5