VTech VT9111 - Manual

INTRODUCTION
IMPORTANT SAFETY INSTRUCTIONS REPLACING THE HANDSET BATTERIES
10. To reduce the risk of electric shock, do not
disassemble this product. If service or
repair work is required, contact VTech
Customer Service at 1-800-595-9511.
Opening or removing cabinet parts other
than specified access doors may expose
you to dangerous voltages or other risks.
Incorrect reassembling can cause electric
shock when the appliance is subsequently
used.
11. Do not overload wall outlets and extension
cords as this can result in the risk of fire or
electric shock.
12. Unplug this product from the wall outlet:
a) When the power supply cord or plug
is damaged or frayed.
b) If liquid has been spilled into the
product.
c) If the product has been exposed to rain
or water.
d) If the product does not operate
normally by following the operating
instructions. Adjust only those controls
that are covered by the operating
i n s t r u c t i o n s b e c a u s e i m p r o p e r
adjustment of other controls may result
in damage and will often require
extensive work to restore the product
to normal operation.
e) If the product has been dropped and
the cabinet has been damaged.
f) If the product exhibits a distinct change
in performance.
13. Avoid using a telephone (other than a
cordless type) during an electrical storm.
There may be a remote risk of electric
shock from lighting.
14. Do not use the telephone to report a gas
leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
When using your telephone equipment, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked
on the product.
3. Unplug this product from the wall outlet
before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for
cleaning.
4. Do not use this product near water (for
example, near a bath tub, kitchen sink, or
swimming pool).
5. Do not place this product on an unstable
cart, stand, or table. The product may fall,
causing serious damage to the product.
6. Slots and openings in the cabinet and the
back or bottom are provided for ventilation.
To protect it from overheating, these
openings must not be blocked by placing
the product on the bed, sofa, rug, or other
similar surface. This product should never
be placed near or over a radiator or heat
register. This product should not be placed
in a built-in-installation where proper
ventilation is not provided.
7. This product should be operated only from
the type of power source indicated on the
marking label. If you are not sure of the type
of power supply to your home, consult your
dealer or local power company.
8. Do not allow anything to rest on the power
cord. Do not locate this product where the
cord will be abused by persons walking on
it.
9. Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points or short out
parts that could result in a risk of fire or
electric shock. Never spill liquid of any kind
on the product.
1. Remove the battery case by pressing on
the ridged lines and sliding downward.
2. Discard the old battery pack. Don't put
the old battery pack in a trash compactor
or a fire - it could burst.
IMPORTANT: Do not dispose of this battery
in household garbage. For
information on recycling or
proper disposal, consult your
local solid waste collection or
disposal organization.
3. Place the new battery pack in the battery
compartment. Make sure the metal
contacts on the underside of the battery
are aligned with charging contacts in
battery compartment.
4. Replace the battery cover by sliding it into
place.
5. The new battery pack must be charged
before using your telephone. Place the
handset in the cradle of the base unit to
allow it to charge for 24 hours. Maximum
battery life between charges is more than
7 hours of continuous talk time or 6 days
of standby.
Parts Check List:
1. Handset
2. Base Unit
3. Telephone line cord
4. AC adapter
5. Battery Pack
6. Wall mounting bracket
VTECH COMMUNICATIONS LTD.
USER’S MANUAL
IMPORTANT
BEFORE USING YOUR NEW PHONE, WE
STRONGLY RECOMMEND YOU READ THIS
MANUAL THOROUGHLY.
V T 9 1 1 1 / V T 9 1 1 5 V T 9 1 1 1 / V T 9 1 1 5 V T 9 1 1 1 / V T 9 1 1 5
900MHz ANALOG CORDLESS TELEPHONE 900MHz ANALOG CORDLESS TELEPHONE 900MHz ANALOG CORDLESS TELEPHONE 900MHz ANALOG CORDLESS TELEPHONE 900MHz ANALOG CORDLESS TELEPHONE
Copyright 1998 for VTECH COMMUNICATIONS LTD.
Printed in China. ISSUE 0
91-5017-32-00
VTECH
BASE UNIT
TELEPHONE LINE
CORD
HANDSET
AC ADAPTER
WALL MOUNT BRACKET BATTERY PACK
CAUTION: To reduce the Risk of Fire or
Injury to Persons, Read and
Follow these instructions:
1. Use only VTECH battery.
2. Do not open or mutilate the battery.
Released electrolyte is corrosive and
may cause damage to the eyes or skin.
It may be toxic if swallowed.
3. Exercise care in handling batteries in
order not to short the battery with
conducting materials such as rings,
bracelets, and keys. The battery or
conductor may overheat and cause
burns.
4. Do not dispose of the battery in a fire.
The cell may explode.
1
3 2