ViewEra V202 - Manual (Page 6)

2.2 Installation
The monitor is equipped with an automatic sensing AC power adapter for a voltage range from 100 to
240 VAC at a frequency of 50 to 60 Hz. Before connecting the cables, please make sure that the
monitor and the computer power are both turned off. Please follow the steps to install your monitor.
2.2.1 Connecting the signal cable
Plug one end of the VGA cable or DVI cable to the computer and the other end to the video signal
connector on the monitor, and then tighten the two screws on the cable connector.
2.2.2 Connecting power cord
Plug one end of the power cord into the input port of the monitor power supply and then insert the
other end into the socket of the electrical source.
2.2.3 Connecting the audio cable
Plug one end of the audio cable to audio jack on either computer or video device and the other end
to audio jack on the monitor.
2.2.4 Installing the monitor base
1. Take the monitor and the base out of the box and place its side on the table.
2. Align the monitor base with the monitor arm and then push the base into the knighthead on the
monitor arm until the monitor base is securely connected to the monitor arm.
2.2.5 Power on
Turn on your monitor and computer. The LED indicator will light green (or blue) when the screen is
under normal condition. If the LED indicator lights red, please check if the signal cable is securely
connected between the computer and the monitor.
4