Vinotemp 700 User Manual
FOR YOUR PERSONAL WINECELLAR
BEFORE PROCEEDING, PLEASE READ ALL INSTRUCTIONS FIRST!
The tools required for disassembly and reassembly of your custom Winecellar are as follows:
Phillips Head Screwdriver
1/4” Nut Driver
You will need a clean level area. It will be necessary for 2 or
people to help in disassembly to
complete the following instructions:
Remove shipping carton and packing material with exception to pallet. Open door
remove the plastic bag containing four or six casters depending on the size of
Place the cardboard on ground behind winecellar.
With the 7/16” wrench, remove the two baits at the top of cooling unit. Carefully
slide the unit out and place it on the ground out of the way in an upright position,
being careful not to damage the insulated bottom.
If you have a model 700, remove the middle
by removing center screw in
back brace, then remove screws on top
bottom of middle bar.
Carefully remove the screws that are on the cabinet side of the hinge making sure
someone is holding the door while screws
being removed. Place the door on
cardboard to the side of winecellar.
With the Phillips Head Screwdriver or 1/4” Nut Driver carefully remove the
screws holding the bottle racks, be sure to save the screws which
the top back of rack. Remove entire rack. (Standard cellar trellis racks)
Models with horizontal support
(single door 440
single door 400),
must be removed prior to removing rack.
Removal of E-Line (Black Metal) Racks:
-Remove the cellar trellis row sticks from the top of rack.