Viking W10345054 - Manual (Page 8)

15
There are two refrigerator compartment doors. The doors can be
opened and closed either separately or together. There is a
vertically-hinged seal on the left refrigerator door.
• When the left side door is opened,
the hinged seal automatically folds
inward so that it is out of the way.
• When both doors are closed, the
hinged seal automatically forms a
seal between the two doors.
Ice Maker & Ice Storage Bin
Alarm Sound
The ice maker and storage bin are located in the upper left-hand side
of the refrigerator compartment.
Turning the Ice Maker On/Off
The On/Off switch is located on the ice maker.
To turn on the ice maker, press the switch to the “ON” position.
To manually turn off the ice maker, press the switch to the “OFF”
position.
Note: Your ice maker has an automatic shutoff. The ice maker sensors
will automatically stop ice production, but the control will remain in the
ON position.
Opening & Closing Doors
O
p
e
ra
tio
n
14
Moisture Adjustable Produce Drawer
You can control the amount of humidity in the moisture adjustable
produce drawer. Adjust the control to any setting between LOW and
HIGH. LOW (open) for best storage of fruits and vegetables with skins.
HIGH (closed) for best storage of fresh, leafy vegetables.
MeatSavor™/Produce Drawer
The MeatSavor™ drawer is a full-width drawer with adjustable
temperature control. This drawer can be used for large party trays, deli
items, beverages or miscellaneous items. There is a divider to organize
the drawer into sections if desired.
MeatSavor Control
The control, located on the right of the drawer, regulates the air
temperature inside the drawer. Set control to “COLD” to provide
normal refrigerator temperature. Use the COLDEST setting for meats
or other deli items.
• Cold air directed to the MeatSavor™ can decrease refrigerator
temperature. Refrigerator control may need to be adjusted.
• DO NOT place leafy vegetables in the MeatSavor™ drawer. Colder
temperatures could damage leafy produce.
To Remove:
• Lift lid. Pull drawer out to full extension. Tilt the drawer front up and
pull straight out.
To Install:
• Push metal glide rails to the back of the refrigerator. Place drawer
onto rails and slide drawer back until it falls into place.
To Remove Divider:
• Pull drawer completely out and raise the front of the divider to
unhook it from rear wall of the drawer and lift it out.
To Install Divider:
• Hook back of divider over rear wall of drawer and lower into place.
User Settings
P
ro
d
u
ct
C
o
n
tr
o
ls
A
A. Hinged seal