VocoPro KJM-7900 PRO - Manual (Page 4)

Unpacking the KJM-7900 Pro
Carefully remove the KJM-7900 Pro digital mixer from its packaging and operate per manual instructions before discarding the packaging
materials. If it should become necessary to return the unit for any reason the original packaging materials are best suited for transporting
the unit to minimize any potential damage which may not be covered under the standard warranty.
Thank you for purchasing the KJM-7900 Pro. At VocoPro we care about product quality and customer
satisfaction. We know the KJM-7900 Pro will provide years of quality service and reliable music
entertainment for you when used properly.
BEFORE YOU START
PEASE READ CAREFULLY BEFORE USING THE KJM-7900 PRO
WARNING: To avoid shock or serious injury do not attempt
to connect any external devices or cablesto the KJM-7900
without first disconnecting the unit from all power sources.
Connecting an Amplifier to the KJM-7900 Pro
QUICK START ( REAR PANEL HOOK-UP)
Locate the “MASTER 1 OUT” section on the back of the KJM-7900 and the “L” and “R” audio input jacks on your amplification source.
Note: you may need a special “RCA to 1/4”” connector cable if you are using an amplifier with “RCA” type jacks. Connect the “L” and “R”
audio input connectors of your amplifier to the “L” and “R” 1/4” ouput jacks on the back of the unit, labeled “MASTER 1 OUT”. The
“MASTER 1 OUTPUT” section of the KJM-7900 is controled by the “MASTER 1” slide control.
Monoitor Out “L” and “R”
You can connect the “MONITOR OUT, “L and “R” section of the KJM-7900 Pro to a powered monitor, to achieve a seperate monitor
mix for your vocals, by connecting them to the “L” and “R” input connectors of your external “monitor” amplifier. The “MONITOR OUT”
section is controled by the “MASTER 2” slide control.
Record Out “L” and “R”
Connect the “L” and “R” “RECORD OUT” jacks to the left and right ” record in” channels on your recording device. When recording,
set your record levels from the KJM-7900 individual channel controls. The master volume will only give an “audible” volume through your
external speakers and will have no bearing on the record levels.
Master 1 Out
2
If there is a video output connector on your player, locate the “VIDEO IN” section on the back of the KJM-7900 (to the right of the “audio
in” section) and connect your player’s video out connector to the corresponding “VIDEO IN” connector (example: CD, LD or DVD).
Then connect the video line out from the KJM-7900 to your TV monitor’s line in connector. If it is a television be sure to switch it to video
mode.
Connecting a TV Monitor
Connecting a Music Source to the KJM-7900 Pro
“Source section 3” CD, Laser Disc and DVD Players (with or without a video source)
Locate the “AUDIO IN” section on the back of the KJM-7900. Connect the “L” and “R” output connectors of your player to the
corresponding “L” and “R” RCA input jacks on the back of the unit. (example: CD, LD or DVD).