VIEWSONIC V1250 - Manual (Page 54)

ViewSonic Tablet PC V1250 50
100 Mbps
Mode
Nonresponsi
ve If the Ethernet adapter does not
appear to operate in the 100 Mbps
transmission mode:
• Make sure the hub you are using
supports 100 Mbps operation.
• Make sure that your RJ-45 cable
meets the 100BASE-T
requirements.
• Make sure the Ethernet cable is
connected to the hub socket that
supports 100BASE-T mode, not
10BASE-T. The hub may have
both 10BASE-T and 100BASE-T
sockets.
PC Card
Problems PC Cards
(SD/MS Slot)
do not
Function • Make sure you have properly
installed the driver for the card.
• Make sure the card is properly
seated.
• Consult the card’s manual or
contact the vendor for
troubleshooting.
PC Card not
Recognized • Remove and insert the PC Card
again.
• Make sure there is no IRQ
(interrupt request) conflict with the
card. See Windows
® on-line help
for solving IRQ conflicts.
• Reboot the V1250 to see if the
problem persists.
• The card may be defective. Try the
card on another system, if
possible.