Venturer CDG 62 - Manual (Page 2)

20. BEAT CUT switch
21. DC 12V socket
22. AC cord
23. Handle
24. VOCAL CHANGER
25. PITCH control
26. POWER switch
27. MIC INPUT 1 socket
28. TONE control
29. DIGITAL ECHO control
30. TAPE CHANNEL switch
31. FUNCTION switch
32. Tuning scale
33. TUNING control
34. MIC 2 VOLUME control
35. MIC INPUT 2 socket
36. MIC 1 VOLUME control
37. Master VOLUME control
- 1 -
1. Deck A operation buttons
PLAY
REW (REWIND)
F.FWD (Fast Forward)
STOP/EJECT
PAUSE
2. Cassette Deck A
compartment
3. Microphone 1
4. CD door
5. CD SKIP ( / ) button
6. CD REPEAT button
7. CD REPEAT indicator
- 2 -
HOUSE CURRENT
Before use, check that the rated
voltage of your unit matches your local
voltage.
Caution:
To prevent electrical shock, match wide
blade of plug to wide slot, fully insert.
BATTERIES
• Disconnect the AC power cord from
the AC inlet of the unit. Battery power
is cut automatically when it is
connected.
• When the volume decrease, or the
sound distorts, replace all batteries
with new ones.
• Open the batteries compartment and
insert 9 x "D" size batteries as shown
here:
• Do not mix old and new batteries. Do
not mix ALKALINE, standard
(CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
9 x "D" size batteries
DC 12V
12 VOLT CAR ADAPTOR
Connect the adaptor (not included) to
an UL recognised 12 voltage 3A
Cigarette Lighter Receptacle and insert
the adaptor cord plug to the DC input
socket located on the back of the unit.
This model is provided with positive tip
polarity DC input socket as shown here:
Make sure the polarity of the plug of the
car adaptor is also of positive tip polarity.
TURN ON THE UNIT
Press the POWER switch to (ON) turn
on the unit.
NOTE:
After using the unit, press the POWER
switch to (STANDBY) turn off the power.
- 3 -
LISTENING TO THE RADIO
Adjust the VOLUME.
Adjust the DIGITAL ECHO level.
WHEN RECORDING
• The VOLUME, TONE and DIGITAL ECHO controls may be adjusted with no
effect on the recorded signal.
• The PITCH control must be adjusted to the centre position. Otherwise distortion
signal may be recorded.
Adjust the TONE for high or low
frequency range.
Adjust the PITCH control of the music.
(for TAPE only)
1. Set the FUNCTION switch to the
desired position (AM/FM).
FOR BETTER RECEPTION
Repositioning the unit to get better reception.
2. Tune into the desired station.
1. Set the FUNCTION switch to TAPE.
3. Press the PLAY button to begin playback.
2. Insert a cassette into each cassette
holder.
TO STOP PLAYBACK
Press the
STOP/EJECT button.
TO INTERRUPT PLAYBACK
Press the PAUSE button.
To resume play, press the PAUSE button again.
TO FAST WIND
Press the
REWIND or F.FWD button.
Press the STOP/EJECT button to stop winding at the desired position.
WHEN THE TAPE REACHES ITS END
During fast wind or regular play, the tape will stop automatically when its end is
reached.
WHEN BOTH DECK A AND DECK B ARE SET TO THE PLAYBACK MODE
The sound from both decks will be mixed together.
NOTE:
The PITCH control must be adjusted to the centre position otherwise distortion
signal may be played.
- 5 -
FROM DECK A TO DECK B
Played
next
Played
first
TAPE PLAYBACK - continued
1. Set the FUNCTION switch to TAPE. 2. Insert a cassette into each cassette
holder.
3. Press the PLAY button on deck A.
5. Press the PLAY button on deck B. As soon as the tape in deck A reaches
its end and stop , the pause mode for
deck B is be released and playback
starts automatically.
4. Press the PAUSE button on deck B.
- 6 -
Should any trouble occur, disconnect the AC power cord and refer servicing to
qualified personnel.
FCC INFORMATION (For U.S.A. only)
This device complies with part 15 of the FCC Rules. Operations is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesirable operations.
FOLLOW THE ADVICE BELOW FOR SAFE AND APPROPRIATE OPERATIONS.
ON PLACEMENT
• Do not use the unit in places which
are extremely hot, cold, dusty, or
humid.
• Place the unit on a flat and even
surface.
• Do not restrict the air flow of the unit
by placing it in a place with poor air
flow, by covering it with a cloth, or by
placing it on a carpet.
• Never obstruct the ventilation holes
on the rear panel, as increased
internal temperature may affect the
electric parts. In particular, do not
place the system in an airtight rack.
• If using the system near television or
radio, interference may occur. Move
this system away.
ON AC VOLTAGE
• Before use, check that the rated
voltage of your unit matches your
local voltage.
ON SAFETY
• When connecting or disconnecting
the AC cord, grip the plug but not the
cord itself. Pulling the cord may
damage it and thus be hazardous.
• Disconnect from the AC mains, when
the unit is not going to be used for
some time.
• If the AC lead is broken or damaged
or if the copper wires are exposed,
contact a qualified engineer to
replace.
PRECAUTIONS
PARTS IDENTIFICATION POWER CONNECTION
ADJUSTING THE SOUND TAPE PLAYBACK TAPE DUBBING
2. Insert a cassette into
each cassette holder.
3. Press the PAUSE button
on deck B.
1. Set the FUNCTION
switch to TAPE.
For playback For recording
TO STOP DUBBING
Press the
STOP/EJECT buttons of deck A and deck B.
MICROPHONE MIXING (KARAOKE)
4. Press the RECORD button of deck
B, which also engages the PLAY
button.
5. Press the PLAY button on deck A, the
recording of deck B will be
automatically engaged.
1. Connect the microphone(s) (included).
3. Adjust the MIC VOLUME, TONE,
PITCH and DIGITAL ECHO controls.
2. Select a source to be
mixed and play.
4. Start singing.
TV CONNECTION
When the unit is connected to a TV set of either NTSC or PAL color system, the video
image from a CD-G (CD graphics) can be shown on the TV set.
• Sound from the disc is heard from the speakers of this unit.
• Only a TV set with the VIDEO input jack can be connected to watch graphics.
CONNECTION (A) - FOR ALL TV SETS WITH AUDIO AND VIDEO JACKS
Connect the AUDIO and VIDEO jack of the unit to the AUDIO and VIDEO input jack of
the TV set with the connection cable supplied.
8. Deck B operation buttons
RECORD
PLAY
REW (REWIND)
F.FWD (Fast Forward)
STOP/EJECT
PAUSE
9. Cassette Deck B
10. Microphone 2
11. CD PLAY/PAUSE button
12. CD STOP button
13. CD PLAY/PAUSE indicator
14. CD display (Track number)
15. Speaker
16. AUDIO R/L jack
17. VIDEO jack
18. AC Input socket
19. Battery compartment
AUDIO IN
L R
VIDEO IN
ÿþ
AUD IO OUTPUT
R L
VIDEO
OUTPUT
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.
AVOID EXPOSURE TO BEAM.
This product contains a
low power laser device.
TUNING
DECK A
OR
DECK B
DECK B
DECK B
яюэ яюэ яюэ я я я ю
яюэ
яюэ я
яюэ я
DECK B
я
я
яя
я
я
я
я
я
я
я
я
я