Connecting your computer – Vivitek 51" Micro Display Projection TV User Manual
Page 19
13
Connecting Your Computer
Using PC INPUT
1. Turn off the power of the RPTV and Computer.
2. Connect a VGA cable from the VGA CARD of your computer to the PC input in the rear of your RPTV.
3. Connect the Audio Out mini-jack from your computer to the VGA Audio ( L/R ) from the rear of your RPTV.
4. Turn on the power of the RPTV and your computer.
5. Select RGB using the INPUT button on the right side of the RPTV or on the remote control.
VGA
Cable
and
Mini-Jack
(Not
supplied)
Back of Rear Projection TV
RGB TERMINAL
Connecting the
computer to display
the PC MODE
(See page 25)
Do not connect any cable
For service only connector is for
production testting and service
only. Could not connect any
irrelevant computer cable that will
be dameage your RPTV.
Note:
a). The PC input on your RPTV supports High-bandwidth Digital Content Protection (HDCP). HDCP encrypts the
transmission between the video source and the digital display for added security and protection.
b). Refer to your computer User Manual for more information about the video output requirements of the product.
FOR SERVICE ONLY
(RS-232C)
Enter the S-VIDEO or the VIDEO terminal
can be used, but the S-VIDEO overrides
the VIDEO terminal.
Make sure ANALOG/DIGITAL RF
DIGITAL
ANALOG
Inputs are connected correctly.
AUDIO(L/R)
RGB
L
L
L
R
R
R
AUDIO
S-VIDEO
VIDEO
AUDIO
AUDIO
AUDIO
AUDIO
(ATSC only)
(ATSC only)
OUTPUT
DIGITAL
COAXIAL
OPTICAL
Y
Y
P
B
P
B
P
R
P
R
L
L
R
R
AV IN1
AV IN1
AV IN2
AV IN2
COMPONENT IN1 COMPONENT IN2
ANTENNA IN
PC INPUT
PC INPUT
HDMI
CENTER CHANNEL
CENTER CHANNEL
INPUT